Official ILCA (Plastic or Rubber) Daggerboard Stop Set.

ILCA Plastic or the new Rubber daggerboard stop set. Please select the type you require. Note the plastic type is a 'press fit' and the rubber version requires the user to screw the two parts together.These stop sets prevent the daggerboard dropping too low in the daggerboard case.

Please select the type you require.

Both types ILCA Class Legal.

How to assemble the plastic stop set type.

1. Align the first cap fitting to the centre shaft and push down hard to until the shaft is flush with outer side of cap
2. Fit the part assembled unit to the centreboard and then align and snap-on-second cap
3. The caps have shaped sides to fit the shaped angle on daggerboard - Please make sure you the alignment is correct before doing the final pressing together (NB not easy to get apart once pressed together) of the end caps to ensure a perfect fit. 

Note: The caps require a fair amount of pressure to snap together. Suggest use a small G clamp to press together the caps. Do not use a hammer -  it will damage the plastic caps.

Aprende como cuidar tu ropa AQUÍ