The Albacore M2/M7+ from Super Spars are both light and responsive mast sections.

Collection from the Rooster UK Office only.

Features and standard fit out

• Welded on main halyard sheave box.
• Fully anodised section to marine specifications.
• Mast measurement bands fitted.
• High Load Gooseneck fitted.
• Sail Entry fitted.
• Plain Heel plug.
• Main Halyard Slot and block (Note no halyard supplied - Suggest the 4mm dia. Rooster Hailtech rope) See: https://www.roostersailing.com/products/106372 or https://europe.roostersailing.com/collections/all/products/106372
• Jib Halyard Slot
• Mast Pole eye fitting for a Jib Stick

This is the bare mast price, forestay shrouds and main halyard can also be fitted by the Rooster Rigger to your specifications.

Please input below your builder of your Albacore as the mast heel to sheer line dimension is critical to determine the final length of the mast.

Please check your existing mast and compare with the dimension sheet from Super Spars that can be found HERE

This sheer line mark is the datum for the mast measurements as you can see. If in doubt then it best to have the mast over length and the customer cuts down the foot to suit the boat and then fit the mast heel with s/s self tappers or rivets. (A plain type mast heel is supplied)

Forestay and Shroud attachment points. - Note the forestay take off is a 1/8 hole in the mast - (see 14 on drawing)

Jib Halyard pulley, mounted just below forestay attachment. - (See 13 on drawing)

Spreaders, mounting height us - fixed at 2440mm above sheer line datum (See 12 on drawing)

Gooseneck supplied and attached - (See 07 on drawing)

Jib Halyard exit slot - (See 05 on drawing)

Main Halyard exit slot - (See 05 on drawing)

Side entry clam cleat, for Main Halyard (Optional extra). (See 04 on drawing)

Main Halyard haul-up pulley & eye (Optional extra). (See diagram 03 on drawing)

Kicking Strap Tang x1 (Optional extra).

Ovington Albacore - Super spars M2 mast

Mast Properties M2

Mast Properties M7+